How to Season and Store Firewood
Dry firewood gives roughly twice the heat of freshly cut wood, lights easily and keeps your chimney cleaner. Getting it dry is mostly a matter of splitting it, stacking it where the wind can reach it, and waiting. Here is how to season and store logs properly, how to tell when they are ready, and how much space a winter’s supply takes.
Why firewood has to be dry
A freshly felled tree is around half water by weight. Before wet wood can give off useful heat, the fire has to boil that water away — so much of the energy goes up the chimney as steam. The fire burns cooler, makes more smoke, and leaves tar and creosote in the flue, which is the main cause of chimney fires.
| Wood | Moisture content | Useful heat per kg | How it burns |
|---|---|---|---|
| Freshly cut (“green”) | 45–60% | About 2 kWh | Hisses, smokes, hard to light |
| Part-seasoned | 25–35% | About 3–3.5 kWh | Burns, but sooty and sluggish |
| Seasoned or kiln-dried | 20% or less | About 4.1 kWh or more | Lights easily, burns hot and clean |
The target is 20% moisture or less. That is the level recommended by the US Environmental Protection Agency’s Burn Wise programme, and the legal standard in England for the “Ready to Burn” mark on wood sold in volumes under 2 m³.
1. Cut and split it early
- Cut to length first. Logs should be about 3 in (75 mm) shorter than your stove’s firebox — 16 in is the usual US length; 25 cm is common for UK stoves.
- Split anything thicker than your wrist. Wood dries through its cut faces far faster than through bark. Splits about 3–6 in (8–15 cm) across dry well and burn well.
- Do it in late winter or spring if you can, so the wood gets a full summer of drying weather before you need it.
2. Stack it for airflow
Sun helps, but wind does most of the drying. A good stack is:
- Off the ground — on pallets, rails or a log rack, so the bottom row does not soak up moisture and rot.
- In single rows where you have room, with the cut ends facing the prevailing wind. If you stack several rows deep, leave a hand’s width between rows.
- Covered on top only. A roof, a sheet of metal or a tarp over the top keeps rain off; the sides must stay open. Wrapping the whole pile in a tarp traps moisture and grows mould.
- Stable. Keep stacks to about 4 ft (1.2 m) high unless they are supported at the ends, and cross-stack the ends or use posts so the pile cannot topple.
3. Give it time
| Wood | Typical seasoning time (split and stacked) |
|---|---|
| Pine, spruce, fir, larch | 6–12 months |
| Ash, birch, cherry, poplar | About 12 months |
| Maple, beech | 12–18 months |
| Oak, hickory | 18–24 months |
These are for an open, breezy spot. Wood in a damp, shaded corner, or left in unsplit rounds, can take twice as long. Dense hardwoods are worth the wait: they hold the most heat for the space they take — see the species table on the firewood calculator.
4. Check that it is ready
- Use a moisture meter. They are inexpensive and take out the guesswork. Split a log and push the pins into the freshly exposed face, along the grain — the outside of a log always reads drier than the middle. You want 20% or less.
- Look and listen. Seasoned logs are lighter, have cracks radiating from the centre of the cut ends, and bark that is loose or falling off. Two dry logs knocked together ring with a sharp “clack”; wet ones thud.
- Watch it burn. If a log hisses, bubbles at the ends or blackens the stove glass, it is not ready.
5. Store it sensibly
- Keep the main stack away from the house. Woodpiles shelter insects and rodents, and in termite-prone parts of the US a stack against the wall is an invitation. Keep a few days’ supply in a rack near the door instead.
- Bring logs indoors a day or two before burning. It dries off surface damp. Do not store large amounts indoors, and keep logs well clear of the stove itself.
- Burn the oldest wood first, and stack new deliveries separately so they do not get mixed in.
- Do not move firewood long distances. In the US and Canada, invasive pests such as emerald ash borer spread in firewood, and many states restrict moving it. Buy it where you burn it.
How much space does a winter’s wood take?
Measure any stack, or check a delivery, with the firewood calculator. As a guide:
| How you use the fire | US | UK |
|---|---|---|
| Evenings and weekends | 1–2 cords: a single row of 16 in logs, 4 ft high and 24–48 ft long | 3–5 m³ loose (2–3.5 m³ stacked): a row of 25 cm logs, 1.2 m high and 7–12 m long |
| Main heating, cold climate | 3–6 cords | 8 m³+ loose |
If you season your own, you need room for two years’ supply — this winter’s dry wood and next winter’s drying. To compare the cost of wood heat with gas, oil or electricity, use the heating cost calculator.
Burn it cleanly
- Have the chimney or flue swept at least once a year, before the heating season.
- Burn hot, with enough air: a fire left smouldering overnight makes the most smoke and creosote.
- Never burn painted, treated or manufactured wood such as plywood, MDF or pallets marked as chemically treated — they give off toxic fumes.
- Fit a carbon monoxide alarm in any room with a stove or fireplace, and check local rules: some areas restrict wood burning on high-pollution days, and in UK smoke control areas you need an approved (“exempt”) stove or an authorised fuel.